Athena 1470-HE EVO, Перевод оригинальной инструкции

Страница: 42 / 196

PAGE
42
Note: The platform is fitted with a
“
crush-preventing
”
system (ref. Point
5.4.4 EN 280), which gets enabled when the platform lowers and temporarily
blocks it to allow the operator to make sure there are no bystanders near the
machine.
•
With the machine stabilised on the tracks, check the operation of the travel
function with the platform lifted; this test is performed by lifting the
platform to a height that involves an angle of the scissor frames of 20° with
respect to the horizontal (maximum height of transit area 4.5mt) and make
sure that it is possible to travel with the machine only at reduced speed
(light indicator 2 flashing ). Also make sure that at greater heights the
light indicator (2) turns off and that it is not allowed to move.
•
With the machine stabilised on the tracks, check that with the platform
lifted higher than the transport height but lower than the maximum travel
height (light 2 on) and moving on non-level terrain, the machine stops
automatically when the inclination of the frame with respect to the
horizontal exceeds 2°. To resume the control of the machine, it is necessary
to lower the work platform in the transport position.
•
Lift the platform to a height greater than the transport height, check that
the manual and automatic levelling functions are not allowed.
•
With the machine stabilised on the stabilisers, check that even with one
stabiliser in the narrow position the maximum height that can be reached by
the work platform is limited to 7m (floor surface). Check all the stabilisers
one at a time.
•
With the machine stabilised on the stabilisers, make sure that even with one
stabiliser not resting on the ground it is not possible to lift the work platform
above the transport height. Check all the stabilisers one at a time.
•
With the machine stabilised on the stabilisers, make sure that even with one
stabiliser completely extended it is not possible to lift the work platform
above the transport height. Check all the stabilisers one at a time.
•
Operate the emergency button on the remote control (or radio control);
make sure that the engine turns off (both the internal combustion engine and
the electrical engine) and that no functions are allowed. Release the
mushroom-shaped button after this test.