Athena 1470-HE EVO, Перевод оригинальной инструкции

Страница: 41 / 196

PAGE
41
Also make sure that none of the stabiliser cylinders has reached its maximum
extension.
An automatic system allows for the platform to operate only if all the stabilisers
are on the ground and none of them is completely extended.
Moreover, an automatic system allows for the platform to operate only if all the
pins are completely inserted in their housings.
If even one pin is not inserted, an alarm will warn the operator.
Also make sure that the ground under the stabilisers is solid and not slippery.
Also check that the maximum slope under the stabilisers is less than 10°.
2.11 Safety checks on the operation of the platform, to be performed
before use
The instructions given below must be followed.
•
With the platform in the transport configuration, place the machine without
lowering the stabilisers with the frame tilted with respect to the horizontal
by a value greater than 2° on the lateral. Operate the platform lifting
control and make sure that it is not possible to raise the platform.
•
With the platform in the transport configuration, place the machine without
lowering the stabilisers with the frame tilted with respect to the horizontal
by a value greater than 2° on the longitudinal. Operate the platform lifting
control and make sure that it is not possible to raise the platform.
•
With the platform in the transport configuration, lower the stabilisers by
means of the automatic stabilisation selector switch. Make sure that the
tracks are raised from the ground and that the machine levels within 0.5°. A
horn will warn the operator that the frame is within the 0.5° of inclination.
At the end of this procedure, make sure that it is possible to lift the work
platform using the up control.
•
Lift the platform without a load to the maximum height and then lower it a
few times; make sure that the machine works correctly
•
Check the operation of the anti-shearing device. This can be done by lifting
the work platform to a height of about 2 metres above the transport height.
It is necessary to check that the downward movement stops automatically at
a height such that the vertical distance between the ends of the scissors
must be greater than 50mm. Further movements downwards are possible
only after a 3s delay at reduced speed.