ATEN VK2100, Руководство пользователя

Страница: 21 / 127

Chapter 2. Hardware Setup
11
Connections
Installation of the VK2100 is a matter of connecting the appropriate wires.
Refer to the installation diagrams on the pages that follow to setup each device
and use the instructions below as a guide (each step provides a corresponding
page with diagram), and do the following:
Connect the hardware devices to the VK2100 using these instructions:
1. Use the DC Output terminals to wire 12VDC power connections using the
instructions on page 13.
2. Use the Relay terminals to wire relay device connections using the
instructions on page 17.
3. Use the IR/Serial (TX) terminals to wire IR or serial device connections
using the instructions on page 18.
4. Use the Digital I/O terminals to wire digital Input/Output device
connections using the instructions on page 20.
5. Use the RS-232 terminals to wire RS-232 serial device connections using
the instructions on page 22.
6. Use the DB-9 ports to wire RS-232/422/485 serial device connections
using the instructions on page 23.
7. Use a grounding wire to ground the unit by connecting one end of the wire
to the grounding terminal, and the other end of the wire to a suitable
grounded object.
Note: Do not omit this step. Proper grounding helps to prevent damage to
the unit from surges or static electricity.
8. Use an Cat 5e/6 cable to connect the VK2100’s Ethernet port to the
network.
9. Set the Controller ID to the appropriate setting for this unit.
10. Plug the power cord supplied with the package into the VK2100’s 3-prong
AC socket and then into an AC power source.