TrojanTwo-Compact User Guide v3.8
Page | 79
The blades which are currently not intended to be used, can be pulled on the sides.
Turn the brass knob (marked with red circle on above picture) clockwise to tighten a blade
onto position and counter-clockwise to loosen and move it.
Blue lines indicate the pre-diecut lines where the slitter blades will slit the roll.
NOTE:
on above picture it is a continuous roll loaded, but imagine the blue lines as pre-
diecut lines, where only the liner is going under the slitter blades.
5.
Enable the slitter blades
in at
TrojanTwo tab -> Media Settings -> Advanced menu
by selecting the
‘Slitter enabled’ checkbox and pressing ‘Save and Apply’ button.
Save and apply.
6.
The slitter blades will move down onto cut position when save and apply button is pressed and
slitter is enabled. Also 2 additional buttons will appear to be able to move the slitter blades up or
down to check the cutting position and adjust blades position up or down if needed.
7.
Start printing and slitter blades will start cutting as soon as the media starts moving.
8.
Disable the slitter blades (blades will move up) when printing is done to be able to remove the
finished rolls. Slitter blades can be disabled az
TrojanTwo tab -> Media Settings -> Advanced menu
by unselecting the ‘Slitter enabled’ checkbox and pressing ‘Save and Apply’ button.
CAUTION:
Beware of the osciallting blades during print!
Touching the blades during operation can result in serious injury.