TrojanTwo-Compact User Guide v3.8
Page | 35
AUTOSET
Simply put the gap in view and push and hold the AUTOSET button for 1 second. The AUTOSET LED
will remain on when the setup is complete. If the setup is not adequate, the AUTOSET and Output
LEDs will flash 3 times. This may indicate a backing material that is too dense to penetrate.
UP/DN Adjustments
The Label Eye sensor has the ability to "tweak" the setup incrementally. Simply momentarily tap
the AUTOSET (UP ˄) button, or LT/DK (DN ˅) button to adjust the sensor to a more stable and
repeatable setting. This feature is used when the AUTOSET does not provide the optimum setting
initially.
Example: If the label backing material is inconsistent, or the label material has more translucent
areas coming into view, then the sensor may need to be adjusted slightly for this rare occasion.
Having the ability to fine tune the sensor for changing conditions provides a solution that is easy to
implement and simple to understand.
Light/Dark
Push the LT/DK button to change output from Dark On to Light On. Output LED turns on when label
in view, or output LED turns on when gap in view.
1.
Cut a piece from the liner only (peel off the label from top) and put the piece of liner under the dot
at the middle of the LABEL • EYE™ text on the sensor, where the small dot indicates the exact
position of the sensor beam.
2.
Keeping the piece of liner under the sensor beam, press and hold the
‘AUTOSET’
button on the
sensor until only the green AUTOSET LED is lit constantly (the red output and the green autoset
LEDs will start flashing first and then red LED goes off and green LED stays lit if calibration is
successful).
3.
Check detection by moving a label (not gap) into the sensor beam. If sensor is properly calibrated,
then the red output indicator LED will go on indicating that the sensor can differentiate between
gap and label. When only a label gap (liner) is under the sensor, then only the green autoset LED is
lit.
4.
Repeat the calibration in case you do not see the same result as described in point 3 above.
Label eye sensor for detecting label gaps and black marks. Sensor can be moved manually along the
2 rods (indicated with yellow arrow on picture above).
