Routine
Maintenance
3
STERRAD
®
Sterilization System Routine Maintenance Guide
37
and time as needed. (Change the date and/or time BEFORE starting a
cycle.)
To change the
date,
do the following:
1. Open the sterilizer door.
2. Press
START
and
CANCEL
at the same time.
3. The message screen shows the date:
DATE = MON 02/14/99
4. A flashing cursor appears at the day-of-the-week entry.
5. Press
OPEN DOOR
to change the name of the day of the week.
6. Press
CLOSE DOOR
to accept the desired day of the week. The
cursor moves to the next field.
7. Press
OPEN DOOR
to change the displayed numbers.
8. Press
CLOSE DOOR
to accept the desired entry. The cursor moves
to the next field.
9. Press
OPEN DOOR
to change the display.
10. Press
CLOSE DOOR
to accept the information. The display
changes to the time editing mode.
Note:
If you are also going to change the time, skip step
10 below, and step 1 in the following section.
11. At the same time, press
START
and
CANCEL
to exit the date and
time editor.
To change the
time,
do the following:
1. Press
START
and
CANCEL
at the same time.
2. Press
CLOSE
DOOR
until the time display appears:
TIME = 01:10:32 PM or 13:10:32
3. A flashing cursor appears at the hour field.
4. Press
OPEN
DOOR
to change the displayed hour.
5. Press
CLOSE
DOOR
to accept the desired hour. The cursor moves
to the minutes field.
6. Press
OPEN
DOOR
to change the displayed minutes.
7. Press
CLOSE
DOOR
to accept the desired minutes. The cursor
moves to the seconds field.
