Arjohuntleigh Alenti, Инструкция по эксплуатации

Страница: 18 / 64

18
Transfer the resident
Before the resident is transferred to an
Alenti , ensure that:
• the back rest is attached to the correct
side of
Alenti ,
• the safety belt is mounted on Alenti ,
• the resident is undressed and covered.
If using a robe, put it on front to back
(opening towards resident’s back) and
• the resident is in a correct sitting posi-
tion.
After each use, disinfect Alenti to prevent
cross-contamination. See section, Disinfec-
tion Instructions.
From a standing position
(11 steps)
1 Activate the brakes on Alenti and ensure
that they are locked.
2 Fold back the hand rest-handle arm.
3 Adjust the height of Alenti so that the
height of the seat is levelled with the
back of the resident's knees.
(See Fig. 1)
4 Have the resident back up to the Alenti
and feel the chassis gently against his or
her hollow of the knees.
WARNING
To avoid entrapment, make sure to
keep the residents hair, arms and
feet close to the body and use des-
ignated grab supports during any
movement.
WARNING
To avoid falling, make sure that the
resident is positioned correctly and
that the safety belt is being used,
properly fastened and tightened.
WARNING
To avoid resident falling out of the
device, make sure that the arm rest
are folded down during transfer.
5 Help the resident to sit down.
6 Fold forward hand rest-handle arm so
that the resident can hold on to it.
7 Make sure the resident is in an upright
position in the centre of the seat with his
or her:
• buttocks at the back of the seat,
• back against the back rest and
• hands on the hand rest. (See Fig. 2)
8 Secure the resident with the safety belt.
(See Fig. 2)
Adjust Alenti to an ergonomic height for
the caregiver and safe for moving the res-
ident.
10 Release the brakes.
11 transfer the resident and Alenti to the
bath using the transfer handles.
To a standing position (4 steps)
1 Lower Alenti until the resident's feet are
in contact with the floor.
2 Activate the brakes on Alenti and ensure
that they are locked.
3 Fold back the hand rest-handle arm,
away from the resident.
4 Release the safety belt, attach the safety
belt clip to the hand rest-handle arm and
help the resident to stand up.
9
WARNING
To avoid the resident from fall-
ing, always ensure that the
device is in the lowest possible
position before attempting to
transfer, dress or undress the
resident.