Arjohuntleigh Alenti, Инструкция по эксплуатации

Страница: 40 / 64

40
Using the Scale
The display is activated for 4 minutes. After
that, the procedure has to be restarted.
There are two methods to weigh the resident
with the
Alenti Scale:
Method A (5 steps)
The scale is activated before the resident
enters the chair:
1 Push the button. (See Fig. 1)
2 A display test is performed, all segments
are shown for about 1 second.
3 The display shows “WAIT” and after
some seconds, “00”. If the display shows
any figures, push the button again. The
display will then show “00” (net mode).
4 Seat the resident on Alenti. (See Fig. 2)
5 Raise Alenti so both the chair and the res-
ident are clear of the floor or bed.
(See Fig. 3)
The weight of the resident will be shown on
the display.
NOTE
Make sure that the Alenti is in a hori-
zontal position when using the scale,
because the display on a verified scale
will show “TILT” if the lift isn’t horizontal.
NOTE
Do not touch the seat, handles or the
resident during the procedure, because
it can affect the weighing results.
NOTE
To get the net weight of the resident,
place all accessories on the chair
before pushing the button.
Method B (4 steps)
The resident is already sitting on the chair
when the scale is activated:
1 Raise the Alenti so both the chair and the
resident are clear of the floor or bed.
(See Fig. 3)
2 Push the button. (See Fig. 1)
3 A display test is performed, all segments
are shown for about 1 second.
4 If the display shows any figures, push the
button again. The display will then show
“00” (net mode).
When the resident leaves the seat, the dis-
play shows a negative value = the weight of
the resident.
NOTE
To get the net weight of the resident, all
accessories must remain on the seat.
NOTE
If your Alenti is equipped with a scale;
Do not leave anything on the seat that
could disturb the zero range when
reconnecting the battery after charging.