DMX ETH Manual
page 46
rev 1.16
connection multiple times. Any stand-alone program that is set to run on
boot-up will also begin execution.
Hard Reset (Flash Memory)
DMX-ETH comes with the ability to reset all the flash parameters to factory default
settings. This is especially useful if the user has forgotten the device IP.
Hard reset is done by triggering the +LIM/-LIM/HOME/DI1/DI2 digital inputs in a
particular sequence on boot up (
See Boot-up Sequence
section). There are a total of 7
steps that must be met in sequence. Each step has an input pattern that must be met
before moving on to the next step. See chart below:
Hard Reset Step Input Conditions
Step
Condition
+LIM
-LIM
HOME
DI1
DI2
1
ON
ON
OFF
OFF
ON
2
OFF
ON
OFF
OFF
ON
3
ON
ON
OFF
OFF
ON
4
ON
ON
ON
OFF
ON
5
ON
ON
OFF
OFF
ON
6
ON
ON
OFF
OFF
OFF
7
ON
ON
OFF
OFF
ON
Table 7.10
Notes:
-
ON: signal is pulled to GND of opto-supply (regardless of polarity setting)
-
OFF: signal is not pulled to GND of opto-supply (regardless of polarity
setting)
-
For each condition, only one signal needs to change state. This signal is in
bold
At each step, the enable/disable state of the motor will toggle. This is a tool to help
signal to the user when to create the next step condition. See chart below:
Hard Reset Step Motor Enable Status
Step
Condition
Pre-trigger LED
status
Post-triggered LED
status
1
Disabled
Enabled
2
Enabled
Disabled
3
Disabled
Enabled
4
Enabled
Disabled
5
Disabled
Enabled
6
Enabled
Disabled
7
Disabled
Enabled
Содержание DMX-ETH
