Arcus DMX-ETH, Руководство пользователя

Страница: 29 / 78

DMX ETH Manual page 29 rev 1.16
•
High: jump to line 0
•
Enable: enable output polarity
2. Driver Setting – The following driver settings can be configured:
•
Micro-step: 2 to 500 micro-steps
•
Run Current: 100mA to 3Amp
•
Idle Current: 100mA to 3Amp
•
Idle Time:1 to 100 centi-second (10 centi-second = 1 second)
•
Dir: CW or CCW
3. Communication Setup
•
IP Address: Format must be in XXX.XXX.XXX.XXX
•
TOC: Time-out counter (Watch dog)
4. StepNLoop Control – Using the encoder input, StepNLoop control allows
closed loop position verification and correction for the moves. See
StepNLoop control section for details.
5. Misc Settings
•
Enable Decel: Allow for unique deceleration and acceleration values
•
Auto Run 0: Run standalone program 0 on boot-up.
•
Auto Run 1: Run standalone program 1 on boot-up.
•
RZ: Return to zero position after homing routines
•
IERR: Ignore limit error
•
EOBOOT: Configure enable output boot-up state
•
DOBOOT: Configure digital output boot-up state
•
LCA: Set limit correction amount
•
HCA: Set home correction amount
6. Open/Save – Configuration values can be saved to a file and read from a file.
7. Upload/Download
– Configuration values can be uploaded and downloaded.
Note that if the configuration values are changed, it needs to be downloaded to
take effect.
8. Store
– The downloaded parameters can be permanently stored on the non-
volatile memory.
I. Product Information
Figure 6.12
Product information and firmware version and device number is displayed.
Device IP can be changed from the setup screen to support multiple devices
on the Ethernet network