6RL SERIES OPERATION MANUAL
SECTION 6: FRONT PANEL OPERATION
Entire Contents Copyright
2018 by Adaptive Power Systems, Inc. (APS) • All Rights Reserved • No reproduction without written authorization from APS.
6RL Series Regenerative DC Load Operation Manual
Page 56 of 204
6
Front Panel Operation
This Chapter provides an overview of front panel operation for the 6RL Series DC Loads. For
remote control operation, refer to Section 7 “Remote Control Programming” of this manual
for an overview of available programming commands.
6.1
Front Panel Layout
The front panel layout is shown in Figure 6-1 below. The number of controls is kept to a
minimum to ensure simple front panel operation for casual and experienced users alike. The
two shuttle knobs are used to slew parameter values and move through menus as needed
to make selections. All other operations and settings are controlled through the large touch
sensitive LCD display.
Figure 6-1: 6RL Series Front Panel View
The following control elements are available on the front panel:
(1)
Touchscreen display
Used for selection of set values, menus and settings, as well as display of actual values and status.
The touchscreen can be operated with the fingers or with a stylus.
(2)
Rotary knob with push button function
Left knob (turn): adjusting the voltage, power or resistance set values, or setting the parameter values
in the menu.
Left knob (push): selection of the decimal position to be changed (cursor) in the current value
selection. Right knob (turn): adjusting the current set value, or setting parameter values in the menu.
Right knob (push): selection of the decimal position to be changed (cursor) in the current value selection.
(3)
On/Off Button for DC input
Used to toggle the DC load on and off, also used to start a function run. The LEDs “On” and “Off” indicate
the state of the DC input, no matter if the device is manually controlled or remotely
(4)
USB-A port
For the connection of standard USB thumb drives.
The power ON/OFF switch is found in the lower center of the front panel between the two
shuttle knobs. A USB memory stick port is located on the right hand side.
Содержание 6RL Series
Страница 203: ......
