APS 6RL Series, Руководство по эксплуатации

Страница: 14 / 204

6RL SERIES OPERATION MANUAL
SECTION 2: FRONT MATTER
Entire Contents Copyright

2018 by Adaptive Power Systems, Inc. (APS) • All Rights Reserved • No reproduction without written authorization from APS.
6RL Series Regenerative DC Load Operation Manual Page 14 of 204
LETHAL DANGER - HAZARDOUS VOLTAGE
Electrical equipment operation means that some parts can be under hazardous
voltage. Therefore all parts under voltage must be covered! This applies to all
6RL Series models.
All work on connections must be carried out under zero voltage (output not connected to
any power supply) and may only be performed by qualified and informed persons. Improper
actions can cause fatal injury as well as serious material damage.
Never touch cables or connectors directly after unplugging from mains supply as
the danger of electric shock remains!
Never touch the contacts on the DC Input terminal directly after switching off the
DC Input, because there still can dangerous voltage present, sinking more or less slowly
depending on the load! There also can be dangerous potential between negative DC Input
to PE or positive DC Input to PE due to charged X capacitors, which may not discharge.
Always follow these five safety rules when working with electric devices:
1. Disconnect completely
2. Secure against reconnection
3. Verify that the system is dead
4. Carry out earthing and short-circuiting
5. Provide protection from adjacent live parts
DO NOT SERVICE OR ADJUST ALONE.
Do not attempt internal service or adjustment unless another person, capable of rendering
first aid and resuscitation, is present.
DO NOT EXCEED INPUT RATINGS.
This instrument may be equipped with a line filter to reduce electromagnetic interference
and must be connected to a properly grounded receptacle to minimize electric shock
hazard. Operation at line voltages or frequencies in excess of those stated on the data plate
may cause leakage currents in excess of 5.0 mA peak.
DO NOT SUBSTITUTE PARTS OR MODIFY INSTRUMENT.
Because of the danger of introducing additional hazards, do not install substitute parts or
perform any unauthorized modification to the instrument. Return the instrument to an
Adaptive Power Systems Sales and Service Office for service and repair to ensure that safety
features are maintained.
Instruments that appear damaged or defective should be made inoperative and secured
against unintended operation until they can be repaired by qualified service personnel.