APS 6RL Series, Руководство по эксплуатации

Страница: 141 / 204

6RL SERIES OPERATION MANUAL
SECTION 7: REMOTE PROGRAMMING
Entire Contents Copyright

2018 by Adaptive Power Systems, Inc. (APS) • All Rights Reserved • No reproduction without written authorization from APS.
6RL Series Regenerative DC Load Operation Manual Page 141 of 204

Condition “Local“ is active (check the display or control panel on the front of your
unit), which will prevent any remote control

The unit is already remotely controlled by another interface

The unit in setup mode, means the user has accessed the setup menu and not left it
yet
Switch a unit to remote control:
If you are using SCPI command language, send a text command (the space is required):
SYST:LOCK˽1 or SYST:LOCK˽ON
Leaving remote control can be done in two ways: using the dedicated command or by
switching the unit to “Local” condition. We will consider the first option, because this is
about programming.
E
xit remote control:
If you are using SCPI command language, send a text command (the space is required):
SYST:LOCK˽0 or SYST:LOCK˽OFF
7.12.2 SCPI Command Syntax
The following syntax formats are supported for commands and/or queries:
Format Description
Values This numeric value corresponds to the value in the display of the unit and depends on the
nominal values of the unit. Rules:
- The value must be sent after the command and separated by a space
- Instead of a numeric value you can also use:
MIN corresponds to the minimum value of the parameter
MAX corresponds to the maximum value of the parameter
<NR1> Numeric values without decimal place
<NR2> Numeric values with decimal place
<NR3> Numeric values with decimal place and exponent
<NRf> <NR1> or <NR2> or <NR3>
Unit V (Volt), A (Ampere), W (Watt), OHM, s (Seconds)
<CHAR> 0..255: Decimal value
<+INT> 0..32768: Positive integer value (output from unit)
<B0> 1 or ON: Function is/will be activated
0 or OFF: Function is/will be deactivated
<B1> NONE: manual operation active, switching to remote control possible
LOCal: local (manual) operation only, reading of data possible
REMote: unit is in remote control
<ERR> Error with number (-800 to 399) and description
<SRD> String data, various formats:
- IP address as number string with dots as separator, for example “192.168.0.2“
- Key words, for example AUTO or OFF
<Time> [s]s.s[s][s][s][s][s][s] / Default format is seconds (s.s)
; The semicolon is used separate multiple commands within one message
: The colon separates the SCPI keywords (main system, subsystems)
[ ] Lowercase letters and the content of square brackets are optional