AMX NXD-700i, Руководство по эксплуатации/справочник

Страница: 69 / 152

Setup Pages and Descriptions
57 NXD-700i & NXT-CA7 7” Modero Touch Panels
Calibrate Page
The Calibrate page (FIG. 56) allows you to calibrate the touch panel for maximum sensitivity.

Press and hold the Front Setup Access button for 6 seconds to access the Calibrate page.

Press the crosshairs to calibrate the panel and return to the last active firmware page.
System Settings Page (Cont.)
Master IP/URL: Sets the Master IP or URL of the NetLinx Master.
(ETHERNET Only - disabled when USB is selected)
Master Port Number: Enters the port number used with the NetLinx Master.
• Default value is 1319. (ETHERNET Only - disabled when USB is selected)
Username/Password: If the target Master has been previously secured, enter the alphanumeric string
(into each field) assigned to a pre-configured user profile on the Master.
This profile should have the pre-defined level of access/configuration rights.
USB IP Settings: Sets IP settings through the mini-USB port.
DHCP/Static: Switches between HDHCP and Static connections.
IP Address: The IP address of the device
FIG. 56 Calibrate page
If the calibration was improperly set and the Calibrate page cannot be reached
through the panel’s firmware, this firmware page may be accessed via
G4 Web Control. Navigate to the Protected Setup page and press the Calibrate
button through the VNC window. This action causes the panel to go to the
Calibrate
page seen above, where the touch panel may be physically re-calibrated again using
the above procedures.