AMX NXD-700i, Руководство по эксплуатации/справочник

Страница: 20 / 152

NXD-700i - Installation
8 NXD-700i & NXT-CA7 7” Modero Touch Panels
5.
From along the internal surface of the Faceplate, remove the six buttons by gently bending each Button
latch up and pulling the button outwards.
6.
Remove the pair of clear light pipe strips by bending the two black light pipe latches inwards and pulling
out the strip.
7.
Grasp the No-Button Trim Ring on both sides and fit it into the groove along the outside surface of the
Faceplate (made available by the removal of the previous Trim Ring).
8.
Gently insert the Trim Ring latches into their corresponding openings on the outer surface of the internal
Faceplate (FIG. 7).
9.
Firmly press down around the No-Button Trim Ring until all of the latches are securely inserted into their
openings on the Faceplate, and the No-Button Trim Ring is securely fastened.
Verify the No-Button Trim Ring is firmly inserted onto the Faceplate and that there are no gaps between
this Trim Ring and the outer surface of the Faceplate.
10.
Place the Faceplate back onto the main NXD-700i unit.
Make sure to align the Microphone, Light, and PIR Motion sensor locations on the main unit to their
respective openings on the Faceplate assembly.
Installing the Button Trim Ring
The outer No-Button Trim Ring is secured to the Faceplate with plastic latches. In order to re-install the Button
Trim Ring back onto an NXD panel which has had the default Button Trim Ring features removed; you must
first remove the No-Button Trim Ring:
1.
To remove the Faceplate, simply pull it away from the panel by gently tugging it outwards until the entire
Faceplate comes away from the panel.
2.
Turn the Faceplate over to expose the inside surface and view the Trim Ring latches.
3.
In a single motion, press down and then outwards on the three Trim Ring latches located along the top of
the internal surface of the Faceplate to begin removing the Trim Ring.
Removing the Internal Faceplate from the panel exposes the pushbuttons openings left from an earlier
removal of the pushbuttons and LEDs.
4.
Gently tug along the edges of the No-Button Trim Ring and work your way around the edges to remove it
from the Faceplate (FIG. 8).
FIG. 7 Inserting the No-Button Trim Ring
No-Button Trim Ring
Faceplate (outer surface shown)
Hollow button openings