Ametek Sorensen SG Series, Руководство по программированию

Страница: 26 / 149

IEEE/RS232 Configuration and Remote Programming SG Series Programming
3-8
M550129-03 Rev L
3.3.3
Power-On GPIB Service Request (PON SRQ) Selection
Set the rear panel PON SRQ switch to ON to cause a GPIB service request
to be sent to the computer controller when the supply is turned on.
POWER-ON GPIB SERVICE REQUEST (PON SRQ) SWITCH
Switch Position Description
ON Power-On SRQ selected
OFF No Power-On SRQ selected
Refer to your specific GPIB controller card manual for further details on serial
polling.
3.3.4
Shield Ground
Connects GPIB cable shield to chassis ground.
3.3.5
Address Selection
The address selection for a unit is the GPIB address of that device (1-30).
SCPI reserves channel 0 as the global channel to address all channels.
The SGA/SGe address selection is binary with switch A0 as the LSB, and
with switch A4 as the MSB. The rear panel switch illustration in Section 3.3.1
shows the address selection 00101 in binary (5 decimal).
The SGI address is selected and enabled from a list in the Remote menu.
See SGI Operation manual for more details on Remote menu, Navigation and
Editing.
ADDRESS SWITCHES
Switch Position Description
ON 1
OFF 0