Amada RG35S-100, Руководство оператора, Страница: 87 / 110

V-43
6 Remove the
worksheet from the
machine, and check
the bend angle as
shown right.
7 When the worksheet is bent to the desired angle, the bending
procedure is completed.
When the worksheet is not bent to the desired angle, do as
described below.
(a) When the bend angle is larger than the desired angle, set the
worksheet again, and repeat steps 1 to 6 above to bend the
worksheet to the desired angle.
(b) When the bend angle is smaller than the desired angle, lower
the multiple closing limit of the ram, set a new worksheet, and
bend it as described in steps 1 to 6 above.
CAUTION
O
Do not turn the multiple closing limit
setting handwheel counterclockwise with
the bar pedal pressed and held. Doing so
may break the multiple closing limit
setting mechanism. Even when the
handwheel is turned counterclockwise,
the ram does not open.
O
To adjust the multiple closing limit of the
ram to a lower position, release the bar
pedal to open the ram, turn the multiple
closing limit setting handwheel
counterclockwise, and press the bar pedal
again.