Amada RG35S-100, Руководство оператора, Страница: 83 / 110

V-39
4 Clear the pedal stopper, and fully press the bar pedal.
The ram closes to the multiple closing limit and stops.
5 With the bar pedal
fully pressed, turn the
multiple closing limit
setting handwheel
clockwise to close the
ram to such a position
that the clearance
between the punch
nose and die top
becomes 5 mm {0.2
in.}.
6 With the bar pedal
fully pressed, tighten
the handwheel lock
knob to lock the
multiple closing limit
setting handwheel.
7 Push back the rising
speed change
position setting lever.
The rising speed
change position is set.
NOTE
O
The required press capacity cannot be obtained at any speed other than
the bending speed. (The maximum press capacity cannot be obtained
at the approach speed.) Before bending, check the rising speed
change position.
8 Release the bar pedal.
The ram opens to the maximum opening limit or temporarily set
multiple opening limit and stops.
10-2. Setting multiple opening limit
Set the multiple opening limit of the ram with the multiple opening limit
setting lever to such a position that the worksheet can be moved in and
out of the machine without any problems. (For the setting procedure,
refer to “4-1. Preparing for removing tools” in this Part.)