Amada RG35S-100, Руководство оператора, Страница: 58 / 110

V-14
5-3. Installing punches
WARNING
O
When installing a punch, do not support it
from below with your hand as shown
below. Otherwise you may get your hand
or fingers pinched.
After installing the dies, install the punches to the punch holders as
described below.
NOTE
O
When installing sectionalized punches
and dies, stagger them by about 5 mm
{0.2 in.} as shown right to prevent the
worksheet from being scratched.
PUNCH
DIE
ABOUT 5 mm {0.2 in.}
1 Slide the punch into
the V-groove of the
die as shown right.
2 Determine the
installation position of
the punch by sliding it
left and right, and
lightly tighten the
fixing bolts of the
punch clamping plate
or plates.
UPPER
BEAM
PUNCH
HOLDER
CLAMPING
PLATE
PUNCH
2 to 3 mm {0.08 to 0.12 in.}