Amada RG35S-100, Руководство оператора, Страница: 81 / 110

V-37
9. SETTING TOOL ORIGIN
WARNING
O
Never put your hand or hands between the
punches and dies.
O
Apply to the installed tools a pressure that
is not higher than the allowable tonnage
marked on them. Unless a proper
pressure is applied to them, the tools may
break and scatter in a dangerous manner.
After aligning the tools, set their origin as required. Once set, the tool
origin comes convenient for bending jobs that must be repeatedly
performed.
Do as described below, and record the value of the digital multiple
closing limit display when the worksheet is bent to an accurate angle.
When you set the digital multiple closing limit display to the recorded
value, you can repeat the same bending job.
1 With the bar pedal fully pressed, turn the multiple closing limit
setting handwheel clockwise to apply the pressure until the pointer
of the pressure gauge indicates the NC9 value.
WARNING
O
If the allowable tonnage of the installed
tools is smaller than the NC9 value, set
their origin with a pressure smaller than
the allowable tonnage.
2 When the pointer of the pressure gauge indicates the NC9 value,
press the reset button of the digital multiple closing limit display.
The display is reset to “0”.
PRESSURE
GAUGE
PRESS
RESET BUTTON DIGITAL UPPER END DISPLAY
IS RESET TO "0" POINTER
INDICATES
NC9 VALUE
Model Tool origin setting pressure (NC9 valve)
RG35S 22 kN {2.53 US tonf}
RG50, RG80 53 kN {5.95 US tonf}
RG100 58 kN {6.50 US tonf}