Amada RG35S-100, Руководство оператора, Страница: 62 / 110

V-18
5 Place a worksheet
along the entire length
of the dies, clear the
pedal stopper, and
press the bar pedal to
apply a pressure
lower than the
allowable tonnage of
the tools and bring the
punch holders into
tight contact with the
upper beam.
PRESSURE GAUGE
6 With the upper beam and punch holders in tight contact, retighten
the clamping bolts of the punch holders.
6-2. Installing punches rearside front
WARNING
O
If you reach between the upper beam and
ram to install the clamping plates at the
rear of the punch holders, you may get
your hands pinched. Never do so.
O
When you install the clamping plates at
the rear of the punch holders, turn off the
power of the machine and optional
backgauge, and go to the rear of the
machine.
Depending on the bend shape of
parts, the punches may have to be
installed rearside front as shown
right. In such a case, install the
punches as described below.
1 Turn the POWER ON/OFF
keyswitch to OFF, and remove
the key from the keyswitch.
FRONT