30
•
MN-35947
•
Rev 15
•
01/18
•
Combitherm® CT PROformance™ and CT Classic Series Installation Manual
#429 - 01/18
DUE TO ONGOING PRODUCT IMPROVEMENT, SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE.
WWW.ALTO-SHAAM.COM
eleCtriCal - CtP20-10e
(no CorD, no PluG, DeDiCateD CirCuit reQuireD)
WITH COMBISMOKER
®
OPTION
ECO STANDARD
**PROpower™ OPTION
ECO STANDARD
**PROpower™ OPTION
VOLTAGE
PH
HZ
AWG
CONNECTION
AMPS
kW
BREAKER
AMPS
kW
BREAKER
AMPS
kW
BREAKER
AMPS
kW
BREAKER
208 – 240
3 50/60 1 – 1/0
L1, L2, L3, G
78.8 – 90.9 28.4 – 37.8
80 – 90
98.8 – 114 33.2 – 44.2 100 – 125 81.3 – 93.8 28.9 – 38.5 90 – 100 101.3 – 116.9 33.7 – 44.9 110 – 125
380 – 415
3 50/60 4 – 3
L1, L2, L3, N, G
48.2 – 52.5 32.3 – 37.8
63
60.5 – 65.8 37.1 – 44.2
63 – 80
50.9 – 55.4 32.8 – 38.5
63
63.1 – 68.7 37.7 – 44.9
100
440 – 480
3* 50/60 6 – 4
L1, L2, L3, G
41.7 – 45.5 32.4 – 37.8
50
52.2 – 57
37.2 – 44.2
60
43 – 46.9 32.9 – 38.5
50
53.6 – 58.5 37.8 – 44.9
60
*ELECTRICAL SERVICE CHARGE APPLIES
**NO-COST OPTION ON ELECTRIC MODELS
WeiGHt
SHiP DimenSionS
Pan CaPaCitY
NET
905 lbs est
411 kg
(L x W x H)
56" x 45" x 87"*
FULL–SIZE:
20" x 12" x 2-1/2"
Twenty (20)
PRODUCT MAXIMUM: 240 lb (109 kg)
SHIP 1052 lbs*
477 kg*
(1422 x 1143 x 2210mm)*
GN 1/1:
530 x 325 x 65mm
Twenty (20)
VOLUME MAXIMUM: 150 quarts (190 liters)
*DOMESTIC GROUND SHIPPING INFORMATION. CONTACT FACTORY FOR EXPORT
WEIGHT AND DIMENSIONS.
**HALF-SIZE SHEET:
18" x 13" x 1"
Twenty (20)
**ON WIRE SHELVES ONLY. ADDITIONAL WIRE SHELVES
REQUIRED FOR MAXIMUM CAPACITY
Water reQuirementS
Water QualitY StanDarDS
tWo (2) ColD Water inletS - DrinKinG QualitY*
one (1) treateD Water inlet: 3/4" NPT connection. Line pressure 30 psi minimum dynamic and
90 psi maximum static (200 to 600 kPa) at a minimum flow rate of 0.80 gpm (3 L/min).
one (1) untreateD Water inlet: 3/4" NPT connection. Line pressure 30 psi minimum dynamic and
90 psi maximum static (200 to 600 kPa) at a minimum flow rate of 2.64 gpm (10 L/min).
* Both inlets can be from same source. Divide using a manifold. Run one side through treatment device before running to oven.
Must meet line pressure and flow rate specifications for both inlets.
Water Drain: 1-1/2" (40mm) connection with a vertical vent to extend above the exhaust vent.
materials must withstand temperatures up to 200°F (93°C).
It is the sole responsibility of the owner/operator/purchaser of this equipment
to verify that the incoming water supply is comprehensively tested and
if required, a means of “water treatment” provided that would meet
compliance requirements with the published water quality standards shown
below. Non-compliance with these minimum standards will potentially
damage this equipment and/or components and void the original equipment
manufacturer’s warranty. Alto-Shaam recommends using OptiPure
®
[www.
optipurewater.com] products to properly treat your water.
Contaminant
Free Chlorine
Hardness
Chloride
pH
Silica
Total Dissolved Solids (tds)
inlet Water requirements
Less than 0.1 ppm (mg/L)
30-70 ppm
Less than 30 ppm (mg/L)
7.0 to 8.5
Less than 12 ppm (mg/L)
Treated line: 50-125 ppm
Untreated line: 50-360 ppm
ClearanCe reQuirementS
left:
0" (0mm)
18" (457mm) recommended service access
riGHt:
0" (0mm) Non-combustible surfaces
2" (51mm) door swing or combustible surfaces
toP:
20" (508mm) for air movement
bottom:
5-1/8” (130mm) for legs, air aintake
baCK:
4" (102mm)
4-5/16” (109mm) optional plumbing kit
inStallation reQuirementS
• Oven must be installed level.
• Hood installation is required.
• Water supply shut-off valve and back-flow preventer when required by local code.
DimenSionS: H x W x D
eXterior: 79-1/4" x 35-11/16" x 42-1/4" (2012mm x 906mm x 1072mm)
eXterior WitH reCeSSeD Door:
79-1/4" x 40-11/16" x 42-1/4" (2012mm x 1033mm x 1072mm)
interior: 60-7/16" x 16-1/4" x 28-1/16" (1535mm x 411mm x 712mm)
A= UNTREATED WATER
B= TREATED WATER
C= ELECTRICAL
D= WATER DRAIN
4-1/2
" (1
14mm)
4-1/4" (108mm)
6-11/16" (168mm)
C - at bottom
of oven
A, B, D
39-11/16" (1008mm)
42-1/4" (1072mm)
35-11/16" (906mm)
B
A
D
28-13/16" (732mm)
1-15/16" (49mm)
33-13/16" (858mm)
1" (24mm)
79-1/4" (2012mm)
60-13/16" (1545mm)
59-1/4
" (1504mm)
11-13/16
" (299mm)
22-3/16
" (563mm)
9-3/16
" (233mm)
(C) 7" (178mm)
(A) 5" (126mm)
(B, E) 4-3/16" (106mm)
(D) 3-1/4" (81mm)
C
A
E
D
B
1-11/16" (42mm)
E= OPTIONAL ELECTRICAL
CTP20-10E
ELECTRIC BOILER-FREE
Содержание CT CLASSIC CTC10-10E
Страница 31: ...MN 35947 Rev 15 01 18 Combitherm CT PROformance and CT Classic Series Installation Manual 31 ...
Страница 80: ......
