MN-35947
•
Rev 15
•
01/18
•
Combitherm® CT PROformance™ and CT Classic Series Installation Manual
•
37
#442 - 01/18
DUE TO ONGOING PRODUCT IMPROVEMENT, SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE.
WWW.ALTO-SHAAM.COM
eleCtriCal
(no CorD, no PluG, DeDiCateD CirCuit reQuireD)
MODEL
VOLTAGE
PH
HZ
AMPS
kW
BREAKER
AWG
CONNECTION
CTC20-20E
208 – 240
3
50/60
137.6 – 158.8
49.6 – 66
150-175
4/0
L1, L2, L3, G
380 – 415
3
50/60
84.2 – 91.7
56.4 – 66
100
1 – 1/0
L1, L2, L3, N, G
440 – 480
3*
50/60
72.7 – 79.4
56.5 – 66
80
2 – 1
L1, L2, L3, G
*ELECTRICAL SERVICE CHARGE APPLIES
WeiGHt
SHiP DimenSionS
Pan CaPaCitY
NET
1100 lbs est
499 kg
(L x W x H) 53" x 53" x 87"*
FULL–SIZE:
20" x 12" x 2-1/2"
Forty (40)
PRODUCT MAXIMUM: 480 lb (218 kg)
SHIP
1157 lbs*
525 kg*
(1346 x 1346 x 2210mm)*
GN 1/1:
530 x 325 x 65mm
Forty (40)
VOLUME MAXIMUM: 300 quarts (380 liters)
*DOMESTIC GROUND SHIPPING INFORMATION. CONTACT FACTORY FOR
EXPORT WEIGHT AND DIMENSIONS.
GN 2/1:
650 x 530 x 65mm
Twenty (20)
**ON WIRE SHELVES ONLY. ADDITIONAL WIRE
SHELVES REQUIRED FOR MAXIMUM CAPACITY
*FULL–SIZE SHEET:
18" x 26" x 1"
Twenty (20)
Water reQuirementS
Water QualitY StanDarDS
tWo (2) ColD Water inletS - DrinKinG QualitY*
one (1) treateD Water inlet: 3/4" NPT connection. Line pressure 30 psi minimum dynamic and
90 psi maximum static (200 to 600 kPa) at a minimum flow rate of 0.80 gpm (3 L/min).
one (1) untreateD Water inlet: 3/4" NPT connection. Line pressure 30 psi minimum dynamic and
90 psi maximum static (200 to 600 kPa) at a minimum flow rate of 2.64 gpm (10 L/min).
* Both inlets can be from same source. Divide using a manifold. Run one side through treatment device before running to oven.
Must meet line pressure and flow rate specifications for both inlets.
Water Drain: 1-1/2" (40mm) connection with a vertical vent to extend above the exhaust vent.
materials must withstand temperatures up to 200°F (93°C).
It is the sole responsibility of the owner/operator/purchaser of this equipment
to verify that the incoming water supply is comprehensively tested and
if required, a means of “water treatment” provided that would meet
compliance requirements with the published water quality standards shown
below. Non-compliance with these minimum standards will potentially
damage this equipment and/or components and void the original equipment
manufacturer’s warranty. Alto-Shaam recommends using OptiPure
®
[www.
optipurewater.com] products to properly treat your water.
Contaminant
Free Chlorine
Hardness
Chloride
pH
Silica
Total Dissolved Solids (tds)
inlet Water requirements
Less than 0.1 ppm (mg/L)
30-70 ppm
Less than 30 ppm (mg/L)
7.0 to 8.5
Less than 12 ppm (mg/L)
Treated line: 50-125 ppm
Untreated line: 50-360 ppm
ClearanCe reQuirementS
left:
0" (0mm)
18" (457mm) recommended service access
riGHt:
0" (0mm) Non-combustible surfaces
2" (51mm) door swing or combustible surfaces
toP:
20" (508mm) for air movement
bottom:
5-1/8” (130mm) for legs, air aintake
baCK:
4" (102mm)
4-5/16” (109mm) optional plumbing kit
inStallation reQuirementS
• Oven must be installed level.
• Hood installation is required.
• Water supply shut-off valve and back-flow preventer when required by local code.
DimenSionS: H x W x D
eXterior:
79-1/4" x 43-3/4" x 47" (2012mm x 1111mm x 1192mm)
eXterior WitH reCeSSeD Door:
79-1/4" x 48-3/4" x 47" (2012mm x 1238mm x 1192mm)
interior:
60-7/16" x 24-1/4" x 32-3/4" (1535mm x 616mm x 832mm)
A= UNTREATED WATER
B= TREATED WATER
C= ELECTRICAL
D= WATER DRAIN
NOTES:
ALL DIMS LISTED AS H x W x D
INTERIOR DIMENSIONS: 1535mm X 616mm X 832mm
•
20.20es2
805606
C - at bottom
of oven
A, B, D
47-7/8
"
(1215mm)
47
"
(1192mm)
43-3/4
"
(1111mm)
B
A
D
33-9/16
"
(852mm)
1-15/16
" (49mm)
41-7/8
"
(1063mm)
1
" (24mm)
79-1/4" (2012mm)
4-1/2
" (1
14mm)
4-1/4
" (108mm)
6-11/16
" (168mm)
59-1/4
" (1504mm)
B
D
C
20.20 ELECTRIC
1-11/16" (42mm)
73-5/8" (1869mm)
11-13/16
" (299mm)
22-3/16
" (563mm)
9-3/16
" (233mm)
(C) 7" (178mm)
(A) 5" (126mm)
(B, E) 4-3/16" (106mm)
(D) 3-1/4" (81mm)
A
E= OPTIONAL ELECTRICAL
E
CTC20-20E
ELECTRIC BOILER-FREE
Содержание CT CLASSIC CTC10-10E
Страница 31: ...MN 35947 Rev 15 01 18 Combitherm CT PROformance and CT Classic Series Installation Manual 31 ...
Страница 80: ......
