CrossTrainer Service Manual
27
CrossTrainer Service Manual Rev A 620-7575
Part Installation Procedure – Upper Crank Arm
Parts Needed:
•
Crank Arm (721-0109) Note: They are ordered individually and you may need two.
Tools Needed:
•
3/16 (Allen) Hex Key
•
5/16 (Allen) Hex Key
•
Torque Wrench (foot pounds)
w/5/16 (Allen) Hex Driver
•
¾ inch Cold Chisel
•
Large Flat-Head Screwdriver
•
Short
Punch
•
1/8 (Allen) Hex Key
Procedure
Remove the Upper Crank Arm
1. Using a 1/8 (Allen) hex key, loosen both of the sets screws on the pedal shaft, under the pedal
pad.
2. Using the short punch (or socket), gently tap the shaft into the pedal base until it is clear of the
collar on the outside.
3. Remove the plastic cap from the end of the leg beam bearing housing.
