Agilent Technologies BioCel 1200, Руководство пользователя

Страница: 94 / 106

Chapter 6: Maintenance and troubleshooting
BioCel User Guide
88
!! IMPORTANT !!
You cannot continue the current protocol run
after an emergency stop has been activated.
After an emergency stop button is pushed, all device motion stops and
error messages are generated in the error log as the scheduler attempts
to continue with the protocol.
To recover from an emergency stop:
1. Clean up any spills or debris if necessary.
2. Twist the activated emergency stop button in a clockwise direction.
The spring-loaded button pops out.
3. Close any open doors.
4. Push the reset button on the power panel.
A stop dialog box opens in addition to the Robot Error dialog box
that is already open.
5. Activate the interlock override by turning the key in the power panel.
6. If the protocol includes a pipette task, in the VPrep EStop detected
dialog box, click Retry .
7. If there is a plate in the gripper, move it back to the pickup location:
a. Establish the location that the plate was picked from.
b. In the Robot Error dialog box, click Diagnostics .
c. Gently hold the plate in your fingers, or ask another operator to
do the same.
d. Click Open Gripper to release the plate to your hand.
8. Close all overhead doors.
9. Remove the interlock override by turning the key in the power
panel.
10. Push the reset button on the power panel.
11. Click Abort Process in the stop dialog box.
12. Close and restart VWorks.
When you restart VWorks, communication with the devices that lost
power is re-established.
00006