AGFA Jeti Tauro H3300LED Series, Руководство оператора

Страница: 55 / 113

Jeti Tauro H3300LED Operator Manual
47
Agfa Graphics
Chapter 5
Fig.5-12: General Tab
- Step 4: Navigate to the Quality Tab and check the Mask setting
(outlined in green in Fig.5-13)
and then to
the General Tab and check the Transport adjust
(outlined in blue in Fig.5-12)
. When the media drive belt produc-
es a significant step fault, you can trim the Transport Adjust. The Mask setting is mainly applied while printing
a solid tint to cover some artifact on the image.
Fig.5-13: Quality Tab
- Step 5: Navigate to the Densities Tab and check if the Densities
(outlined in red in Fig.5-14)
for color,
white and primer are defined by the used CPM.
Fig.5-14: Densities Tab
Note : The value is set by default to 100% on the GUI. It is possible to change the densities to insure
a proper opacity for the white or to reach a higher density for the colors or to reach a higher ink ad-
hesion on the media. Modifying these settings can influence the print result.
- Step 6: Navigate to the Quality Tab and check that the number of passes (outlined in blue in
Fig.5-13)
is linked to a CPM and to a quality mode.
Note
: It is possible to change the number of passes, but this can influence the speed and the print
quality.
- Step 7: Proceed to the appropriate printing mode for the print job:
•
“Printing a job in Manual Mode on Jeti Tauro H3300LED”
• “Printing a job in Continuous Mode on Jeti Tauro H3300LED”
Revision 1.0