AGFA Jeti Tauro H3300LED Series, Руководство оператора

Страница: 54 / 113

Jeti Tauro H3300LED Operator Manual
46
Agfa Graphics
Chapter 5
Checking the Settings of a Job in the GUI
Perform the following procedure before starting any new print job.
Procedure: How to Check the Settings of a Job in the GUI
- Step 1: Navigate to the Main Tab and check if media thickness is corresponding with the value
in the
media pane and eventually modify this setting in the GUI or in Asanti. In The Quality tab you can change the
passes and masking if needed.
Fig.5-10: Main Tab
- Step 2: Navigate to the General Tab and check the Head Gap
(outlined in red in Fig.5-11)
.
The theoretical distance between the media surface and the print head should be set to 1.3 mm.
Fig.5-11: General Tab
Note
: Depending on the media properties you may need to adjust this head gap. Specifically, in order
to prevent a collision you can increase the head gap when printing on heat sensitive substrates or
non-flat media. An increase in head gap can reduce overall image quality and can cause side effects
as mist or spray in unprinted areas.
- Step 3: Navigate to the General Tab and check the UV light intensity and UV critical window
(outlined
in green in Fig.5-12)
. In order to limit the impact of the UV light on heat sensitive media, you can trim
and reduce the UV light intensity and the UV critical window (curing over the full media, or only over
the print area or over the full table width). This option influences the productivity.
Revision 1.0