13. Additional information
13.1 Troubleshooting
Malfunction
Troubleshooting
I pulled the activation
– the undamped explosion
handle without the cartridge
pressure will damage the
being installed
puncture unit and render it
unsafe and unusable . It must
be checked and replaced .
– Direct all queries to your
respective service center .
Activation handle does
– Put a drop of ABS oil into
not attach
the coupler . Push up coupler,
attach and remove handle
several times until the coupler
is functioning properly .
– If this doesn’t work the
system has to be sent to your
respective service center .
– Do not try to attach the
handle with force .
– If you are out in the field and
you have no ABS oil with you,
push the coupler up, attach
the handle and then push the
coupler down .
Malfunction
Troubleshooting
The charged activation
– You must leave the full
handle does not come off
cartridge in place .
– Gently push the coupler
upwards, wiggle the handle
from side to side and carefully
try pulling it down .
– In addition apply a drop of
ABS oil to the handle and
turn it to increase lubrication .
– If this doesn’t work the system
has to be sent in for service .
The airbags are difficult
– Were the airbags folded
to remove from the
properly?
compartments and are
– Did the weight of the cartridge
hard to inflate
match the filled weight?
– If you answered both with yes
you have to send the airbag
in for service .
– If you are unsure about either
one of these points, perform a
practice activation .
– If the problem persists send
the ABS-System in for service .
English
34
140325_ABS_GBA_2014_Innenteil_RZ.indd 34
25.03.14 12:59
Malfunction
Troubleshooting
After inflating the
– This noise is due to the
airbags there is a definite
release valve equalizing the
background noise
pressure .
– After a few minutes the
pressure drop should not be
clearly visible any more .
– If the pressure drop is still
clearly visible, the system
needs to be repaired . Send
the ABS-System in for service .
13.2 Warranty
To extend your warranty of the ABS-System from 2 years to
4 years please complete the warranty card on-line no later than
30 days after your purchase under
www.abs-airbag.com
(under
Service/Warranty Card
) .
(The ABS-System does not include the backpack) .
ABS AIRBAGS warrants that the product will meet the specifi-
cations stated in the instructions and ABS AIRBAGS agrees to
replace the product free of charge if the product does not con-
form to the specifications . Notice for replacement must be given
within 60 days of the discovery of the defect . In consideration of
the above promises by ABS AIRBAGS, the buyer agrees to and
accepts the following conditions:
•
That this warranty is in lieu of all other warranties,
expressed or implied;
• That all warranties of merchantability or of fitness for a
particular purpose are hereby excluded and/or waived;
• That the buyer‘s sole remedy shall be to obtain replacement
of the product free of charge from ABS AIRBAGS; and
That this remedy is in lieu of all other remedies or claims for
damages, consequential or otherwise, which the buyer may have
against ABS AIRBAGS .
ABS AIRBAGS shall have no liability for any loss or injury caused,
in whole or in part, by its actions, omissions, or negligence, or for
contingencies beyond its control;
The warranty extends only to you, the original purchaser . It is
not transferable to anyone who subsequently purchases the
ABS AIRBAGS from you .
13.3 Technical data
Volume of airbag: 2 x 85 liter airbags
Weight of system: Approx . 1200g
Release:
Pyrotechnical ignition in the activation
handle
Filling procedure: Within approx . 1 second 90 liters
(23,8 US gallon) of a gas-air mix
is forced into the two airbags while
the remaining approx . 80 liters
(21,1 US gallon) will take 1 .5 seconds
(depending on outside temperature
and elevation) .
English
35
140325_ABS_GBA_2014_Innenteil_RZ.indd 35
25.03.14 12:59
