Telaire Ventostat™ T8100 NS and NSP Series
CO
2
Sensor
User Instructions
T63351-003
September 2014
Page 1 of 4
Amphenol
Advanced Sensors
®
Installing the Sensor
!WARNING!
Before performing service or maintenance operations on
the systems, turn OFF main power switches to the unit.
Electric shock can cause personal injury. Please read and
follow the wiring instructions precisely; miswiring may
cause permanent damage to the product
.
Basic Installation for T8100-NS and NSP
1.
Separate the case into its front and rear sections.
2.
Secure the rear section of the case to the wall or junction box using
the supplied screws, and make necessary wire connections.
3.
Mount the Controller on the base by aligning the top clips and then
securing to the bottom clips. Secure the Ventostat with the supplied
set screw. A one-minute stabilization warmup will take place.
Internal Label
Amphenol Advanced Sensors
6860 Cortona Dr., Suite B
Goleta, CA 93117
www.amphenol-sensors.com
