ABB LD 800HSE, Руководство пользователя

Страница: 68 / 136

Login to Web Server Interface Section 3 Configuration
68 3BDD011677-600 A
In the case of different or unknown configuration file formats execute the steps
described in
Different or Unknown Configuration File Formats .
Identical Configuration File Formats.
1. Check, which linking device acts as Secondary Device.
2. Update the firmware in the Secondary Device using the web interface, refer to
Firmware Update on page 65, but do not download configuration data.
3. After the firmware update is successfully completed, the Secondary Device
will boot.
4. Wait until the Secondary Device is fully operational again:
a. H1 LEDs are flashing
OR
b. status of the Secondary Device has recovered to a green check mark again
as shown in the HSE Device Instance Object dialog in commissioning
mode of Fieldbus Builder FF.
5. Enforce a redundancy switch-over (e. g. by disconnecting the HSE cable at
the Primary Device).
6. Update the firmware in the remaining device (Secondary Device after
redundancy switch-over) using the web interface.
Refer to the LD 800HSE Compatibility Matrix (3BDS009911) to find out the
configuration file format of the firmware releases involved.
The following procedure works only if the configuration file format is the same
for the old and new firmware release. The only impact on process operation is
that caused by a redundancy switch-over.
For firmware updates from 1.50.1.02 to latest version a manually enforced
redundancy switch-over as described in
Step 5 is not required. This will happen
automatically, when updating the still Primary Device using the web interface in
Step 6 .