ABB Endura AZ40, Руководство пользователя

Страница: 31 / 36

CI/AZ40-EN Rev. A 31
Operation modes
The transmitter has 4 modes of operation – all modes are
accessed from the
Operator menu – see Fig. 25:
— Operating – displays real-time process values on Operating
Pages (refer to Section , page 32).
— View – displays diagnostic messages, alarms, output values,
signals and (chart) traces (refer to Section , page 33).
— Log – displays recorded diagnostic, calibration and audit
events and alarms (refer to Operating instruction
OI/AZ40-EN).
— Configuration – enables the transmitter to be configured
(refer to page 21).
Operator menus
Referring to Fig. 25, Operator menus
A
are accessed from any
Operating , View or Log page by pressing the key
B
.
To select Operator sub-menus (indicated by the arrow), press
the key
C
.
CAL shortcut
D
– opens the Calibrate page directly from an
Operator Page , bypassing the Configuration level menus. Press
the key
C
(below the CAL prompt).
Operator menus comprise:
— Operator Pages – displays Operator Pages1 to 5 –
see page 32.
— Data Views – displays enabled data views.
— Logs – displays enabled Log views.
— Alarm Acknowledge – acknowledges the active alarm
displayed in the Alarms View .
— Media Card – displays the status of the SD Card (enabled
only if a removable media module is fitted) and enables the
operator to place the media online / offline.
— Autoscroll (enabled on Operator pages only) – displays
Operator pages 2 to 5 sequentially.
— Enter Configuration (enabled on all pages) – enters
Configuration parameters via the Access Level . Refer to
Operating instruction OI/AZ40-EN for access levels and
password security options.
IMPORTANT (NOTE)
Operator menus cannot be accessed directly from the
Configuration level.
Fig. 25 Operator menus
In Conf Alarm
CAL
A
B
C
D
Autoscroll
Enter Configuration
Data Views
Logs
Alarm Acknowledge