ABB ACS580MV, Руководство по оборудованию

Страница: 79 / 146

Electrical installation 79
Nuts with bonded coating can be used as an alternative to uncoated stainless steel
nuts.
Connection type
The following connection type is recommended when connecting a cable lug (4) to a
busbar:
•
Spring washer (1) and flat washer (2) on each side of the busbar (3) .
Other washers can be used, provided they maintain the required contact pressure.
•
Use cable lugs suitable for M12 bolts. The required tightening torque is 40 Nm.
Lubrication
•
If stainless steel bolts and nuts are used, lubricate the thread and head contact
surface of the bolt using recommended pasts, e.g. Molykote D paste.
Note: If a coated nut (e.g. with bonded molybdenum-disulfide [MoS
2
] coating) is used,
the connection does not have to be lubricated.
Tightening torque
•
Tighten bolted connections with bolts of sizes M10 and greater with the recommended
nominal torque for the bolt size used.
Installing auxiliary, control and serial communication
cables

Further information
See ACS580MV Base frame & TEU layout design for information on:
• Project-specific cable entry
1
2
3 1 2
4
6
5
1 Spring washer (2 pcs. per terminal)
2 Flat washers (2 pcs. per terminal)
3 Busbar
4 Cable lug
5 M12 bolt
6 M12 nut