UP Plus 3D Printer User Manual
1.
In the UP software, click “3D Print”
menu and click “
Calibrate
2.
Click “
Reset”
and click
tus bar should then show 0 values as
per picture)
3.
In the UP software open the
files\UP\Example\Ca
4.
Open the “Calibrate” box form the “3D Print”
5.
3D Print the calibration
6.
After the calibration model is printed, measure the X1 and X2 length
pictures below.
Then enter the measured X1 and X2 values into the appr
Remove the Front Centre ‘L’ shaped component
into the Z box. If it deviates to the right side, the value
value. If the deviates to the left, the value
Finally, measure the height of Front
measures near 40mm, enter 40mm as the value.
Click “OK” to record all these v
4. Troubleshooting
3D Printer User Manual v 2013.6.10
In the UP software, click “3D Print”
Calibrate
”
and click
OK
. (the sta-
tus bar should then show 0 values as
In the UP software open the Calibration model located in “
Calibrate96.UP3
”
e” box form the “3D Print”
calibration model.
After the calibration model is printed, measure the X1 and X2 length, as shown in the
enter the measured X1 and X2 values into the appropriate boxes.
Centre ‘L’ shaped component, and measure its deviation. Put the exact value
into the Z box. If it deviates to the right side, the value to be put into the Z box will be a positive
If the deviates to the left, the value to put into the Z box will be a negative value.
Finally, measure the height of Front Center component, which should be 40mm.
measures near 40mm, enter 40mm as the value.
Click “OK” to record all these values and exit the calibration window.
Troubleshooting
located in “
C:\program
, as shown in the
, and measure its deviation. Put the exact value
be put into the Z box will be a positive
put into the Z box will be a negative value.
be 40mm. If the part
