![background image](http://html.mh-extra.com/html/2gig-technologies/gc3/gc3_user-manual_439576037.webp)
Figure 24
Alarm Report Already Transmitted…Cancel
Being Sent Message
3.
Tap
OK
to dismiss the notification message.
Clearing an Alarm
If an alarm occurs while you are away, the GC3 Panel's Piezo Sounder will
sound for a preset amount of time (as defined by the
Burglary Bell Cutoff
Time
and/or the
Fire Bell Cutoff Time
). Upon entering the premises, the
system emits fast, repeated beeps to warn you that an alarm was set off
while you were away.
NOTE:
Consult your installer to determine how the
Burglary
Bell Cutoff Time
and
Fire Bell Cutoff Time
is configured on
your system. The time can be configured to last
4 minutes
,
8
minutes
,
12 minutes
,
16 minutes
, or
Unlimited
(no cutoff).
The default setting for both features is four (4) minutes.
CAUTION!
If the system emits fast, repeated beeps (instead
of the typical
Entry Delay
beeps), proceed indoors with
extreme caution. For your safety, it is recommended that you
immediately leave the premises, go to a secure location, and
then contact your local authorities for assistance. If you have
any reason to believe an intruder is present, do NOT enter
the premises until the dwelling is deemed safe by local
authorities.
To clear an alarm:
1.
At the
Alarm
screen (after the
Burglary Bell Cutoff Time
or
Fire
Bell Cutoff Time
expires), enter an active, four-digit user code.
Figure 25
Enter Your Code to Clear the Alarm
2.
Depending on how quickly you enter your code, one of the
following occurs:
a.
If you enter your code before the
Alarm Cancel
Time
countdown expires, the following message
appears.
Figure 26
Alarm Report Already Transmitted…Cancel
Being Sent Message
b.
NOTE:
Consult your installer to determine
how the
Alarm Cancel Time
setting is
configured on your system. For compliance
with
ANSI/SIA CP-01-2010
, the factory
default setting is five (5) minutes.
c.
If you enter your code after the
Alarm Cancel Time
countdown expires, the system reveals the
Alarm
History
.
Figure 27
Alarm History
The system clears the alarm. You can also clear the Alarm
History. See "Clear the Alarm History" on page 42.
4 Burglary Protection
Proprietary & Confidential
37
Copyright © 2015 Nortek Security & Control LLC