![background image](http://html.mh-extra.com/html/2gig-technologies/gc3/gc3_user-manual_439576068.webp)
Proprietary & Confidential
10 System Settings
Figure 9
System Ready to Arm (BYPASS) Status
7.
Continue by arming the system. See "Arm the System" on page
31.
After the system is disarmed, bypassed sensors are automatically
removed from the system's
Bypassed Sensors
list, unless the
Auto
Bypass for Manual Bypass
feature is enabled.
NOTE:
Consult your installer to determine if the Auto Bypass
for Manual Bypass feature is enabled. See
"Auto Unbypass
for Manual Bypass" on page 1
.
Removing Sensors from the Bypassed Sensors List
After the system is disarmed, bypassed sensors are automatically
removed from the system's
Bypassed Sensors
list, unless the
Auto
Bypass for Manual Bypass
feature is enabled. If you decide you want
to remove a sensor from the
Bypassed Sensors
list before you arm the
system, use the steps detailed here.
To remove a sensor from the
Bypassed Sensors
list:
1.
At the Home screen, tap
System Settings
.
2.
Enter the Master User Code to access the
System Settings
.
3.
Tap
Bypass Sensors
.
4.
Move the slide control to the left for the desired sensor. This
removes the sensor from the system's
Bypassed Sensors
list.
5.
Tap
t
when finished.
Smart Home Settings
The
Smart Home Settings
menu gives you the ability to add and remove
Z-Wave devices from the network.
NOTE:
Consult your installer to determine if the
Z-Wave
Feature
has been enabled on your system. Some
configurations only make this feature available to the
installer.
NOTE:
This feature is PIN-protected. To use this feature,
you must know the four-digit Master User Code.
Adding a Z-Wave Device to the Network
To add a Z-Wave device to the network:
1.
At the
Smart Home Settings
menu, tap
Add Devices
.
The
Listening for Devices to Add
screen appears.
Figure 10
Listening for Devices to Add Screen
2.
Walk to and trigger the device to transmit.
When the system discovers a device, the system automatically
adds it and the
Adding Device
message appears.
Figure 11
Adding Device
3.
Tap
OK
at the
New Device was Added to the System
message.
Figure 12
New Device was Added to the System Message
Copyright © 2015 Nortek Security & Control LLC
68