ZyXEL Communications OLT-1308, User Manual

Page: 284 / 314

Chapter 38 Command Examples
OLT-1308 Series User’s Guide
284
Use these commands to create a VLAN profile for the downstream traffic. You can also create
VLAN profile for the upstream traffic, replace
downstream
with
upstream
.
The following shows an example rule on the incoming packets from the OLT to the ONU.
• Create a VLAN profile called
VProfile
on fiber port 1.
• Enable the service profile.
• Enable a rule for downstream traffic.
• Set the rule to check packets with a VLAN ID of 14.
• Set the rule action on the matched packets. This rule removes the VLAN tag from the
incoming packets.
action <delete|
exchange| none>
= Specify the action to perform on matched packets.
Enter
delete
to insert a VLAN tag to outgoing packets
or delete the VLAN tag from incoming packets.
Enter
exchange
to replace the VID with the one
specified in the VLAN ID field.
Select
none
to forward packets without any changes.
new-vid <1-4094>
= Enter a VLAN ID (from 1 to 4094) of the packet.
For the
exchange
action, this replaces the packet’s
VLAN ID.
Note: For downstream traffic, this field is
ignored. However, you cannot leave this
field blank. Enter any number.
priority-src
<original| priority-
profile>
= Enter
original
if you don’t want to change the priority
of the packets.
Enter
priority-profile
to change the packet priority
based on the settings in the priority profile configured for
the ONU. If no priority settings are configured for the
matched packets, the TOS-COS settings in the priority
profile apply.
type <ethertype| ipv4|
vlan>
= Sets the rule type.
value <ethertype<0-
65295>|ipv4<1-255>|vid
<1-4094>>
= Specify the Ethernet type, protocol type or VLAN ID.
sysname(config)# vlan-profile VProfile
sysname(config-vlan-profile)# active
sysname(config-vlan-profile)# downstream rule 1 active
sysname(config-vlan-profile)# downstream rule 1 type vlan
sysname(config-vlan-profile)# downstream rule 1 value 14
sysname(config-vlan-profile)# downstream rule 1 new-vid 14
sysname(config-vlan-profile)# downstream rule 1 action delete
sysname(config-vlan-profile)#