Chapter 38 Differentiated Services
MGS3520 Series User’s Guide
319
Figure 199
IP Application > DiffServ
The following table describes the labels in this screen.
38.3 DSCP-to-IEEE 802.1p Priority Settings
You can configure the DSCP to IEEE 802.1p mapping to allow the Switch to prioritize all traffic
based on the incoming DSCP value according to the DiffServ to IEEE 802.1p mapping table.
Table 152
IP Application > DiffServ
LABEL
DESCRIPTION
Active
Select this option to enable DiffServ on the Switch.
Port
This field displays the index number of a port on the Switch.
*
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first
to set the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Active
Select
Active
to enable DiffServ on the port.
Apply
Click
Apply
to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the
Save
link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel
Click
Cancel
to begin configuring this screen afresh.
