Chapter 27 IP Source Guard
MGS3520 Series User’s Guide
256
Figure 151
Advanced Application > IP Source Guard > ARP Inspection VLAN Configure
The following table describes the labels in this screen.
Table 116
Advanced Application > IP Source Guard > ARP Inspection VLAN Configure
LABEL
DESCRIPTION
VLAN
Use this section to specify the VLANs you want to manage in the section below.
Start VID
Enter the lowest VLAN ID you want to manage in the section below.
End VID
Enter the highest VLAN ID you want to manage in the section below.
Apply
Click this to display the specified range of VLANs in the section below.
VID
This field displays the VLAN ID of each VLAN in the range specified above. If you configure the
*
VLAN, the settings are applied to all VLANs.
Enabled
Select
Yes
to enable ARP inspection on the VLAN. Select
No
to disable ARP inspection on the
VLAN.
Log
Specify when the Switch generates log messages for receiving ARP packets from the VLAN.
None
: The Switch does not generate any log messages when it receives an ARP packet from the
VLAN.
Deny
: The Switch generates log messages when it discards an ARP packet from the VLAN.
Permit
: The Switch generates log messages when it forwards an ARP packet from the VLAN.
All
: The Switch generates log messages every time it receives an ARP packet from the VLAN.
Apply
Click
Apply
to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the
Save
link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel
Click this to reset the values in this screen to their last-saved values.