ZyXEL Communications MES3500 Series, User Manual

Page: 312 / 370

Chapter 40 Access Control
MES3500 Series User’s Guide
312
40.3.6 Enabling/Disabling Sending of SNMP Traps on a Port
From the SNMP > Trap Group screen, click Port to view the screen as shown. Use this screen to
set whether a trap received on the port(s) would be sent to the SNMP manager.
Figure 198
Management > Access Control > SNMP > Trap Group > Port
The following table describes the labels in this screen.
Options Select the individual SNMP traps that the Switch is to send to the SNMP station. See
Section 40.3.3 on page 305 for individual trap descriptions.
The traps are grouped by category. Selecting a category automatically selects all of the
category’s traps. Clear the check boxes for individual traps that you do not want the Switch
to send to the SNMP station. Clearing a category’s check box automatically clears all of the
category’s trap check boxes (the Switch only sends traps from selected categories).
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 149
Management > Access Control > SNMP > Trap Group (continued)
LABEL DESCRIPTION
Table 150
Management > Access Control > SNMP > Trap Group > Port
LABEL DESCRIPTION
Option Select the trap type you want to configure here.
Port This field displays a port number.
* Settings in this row apply to all ports.
Use this row only if you want to make some of the settings the same for all ports. Use this
row first to set the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.