Chapter 39 Maintenance
MES3500 Series User’s Guide
295
39.2 Load Factory Default
Follow the steps below to reset the Switch back to the factory defaults.
1
In the
Maintenance
screen, click the
Click Here
button next to
Load Factory Default
to clear all
Switch configuration information you configured and return to the factory defaults.
2
Click
OK
to reset all Switch configurations to the factory defaults.
Figure 188
Load Factory Default: Start
3
In the web configurator, click the
Save
button in the top of the screen to make the changes take
effect. If you want to access the Switch web configurator again, you may need to change the IP
address of your computer to be in the same subnet as that of the default Switch IP address
(192.168.1.1).
39.3 Save Configuration
Click
Config 1
to save the current configuration settings permanently to
Configuration 1
on the
Switch.
Click
Config 2
to save the current configuration settings to
Configuration 2
on the Switch.
Alternatively, click Save on the top right-hand corner in any screen to save the configuration
changes to the current configuration.
Note: Clicking the
Apply
or
Add
button does NOT save the changes permanently. All
unsaved changes are erased after you reboot the Switch.
39.4 Reboot System
Reboot System
allows you to restart the Switch without physically turning the power off. It also
allows you to load configuration one (
Config 1
) or configuration two (
Config 2
) when you reboot.
You can restart the Switch immediately or set the Switch to restart at a specific time.
Click
Management
>
Maintenance
>
Reboot System
to view the screen as shown next.
Summary of Contents for MES3500 Series
