ZyXEL Communications MAX318M2W, User Manual

Page: 20 / 294

Chapter 1 Getting Started
MAX318M2W User’s Guide
20
1.2 WiMAX Device Hardware
Follow the instructions in the Quick Start Guide to make hardware connections.
1.2.1 LEDs
The following figure shows the LEDs (lights) on the WiMAX Device.
Figure 2 The Indoor WiMAX Device’s LEDs on the Front Panel
Table 2 The Indoor WiMAX Device’s LEDs on the Front Panel
LED STATE DESCRIPTION
WIRELESS
On/Off Off The WPS (Wi-Fi Protected Setup) function is
disabled on the WiMAX Device.
Green The WPS function is enabled on the WiMAX Device.
POWER Off The WiMAX Device is not receiving power.
Red The WiMAX Device is receiving power but has been
unable to start up correctly or is not receiving
enough power. See the Troubleshooting section for
more information.
Solid Green The WiMAX Device is receiving power and
functioning correctly.
Blinking Green The WiMAX Device is performing a self-test.
LINK Green The WiMAX service set ID is registered and
operational.
Slow Blinking
Green The WiMAX Device is currently searching for a
channel (approximate blink is speed 1 second per).
Fast Blinking Green The WiMAX Device is currently the process of
joining a WiMAX network (approximate blink speed
is 0.5 second per).
SIGNAL 1~3 The Signal LEDs display the Received Signal Strength Indication (RSSI) of
the wireless (WiMAX) connection.
No Signal LEDS
There is no WiMAX connection.
Signal 1 On The signal strength is less than or equal to -90 dBm
Signal 2 On The signal strength is less than or equal to -80 dBm
Signal 3 On The signal strength is less than or equal to -70 dBm