ZyXEL Communications IES4005M, User Manual

Page: 89 / 236

Chapter 11 Management
IES4005M User’s Guide
89
11.4 Running Configuration Commands
Use these commands to back up and restore configuration and firmware.
This table describes the commands.
hw-monitor fan-speed-threshold
< index > < high > < low >
Sets the high and low fan speed limits for raising an alarm on the
specified fan.
index
: 1-3
high
: 0-15000 in RPM
low
: 0-15000 in RPM
C 13
hw-monitor temperature-threshold
< slot > < index > < high > < low >
Sets the high and low temperature limits for raising an alarm on
the specified module and sensor.
slot
:
1-5
,
1
is the control card.
2-5
are the line cards.
index
: 1-10
high
: -50-100 in degree Celsius
low
: -50-100 in degree Celsius
C 13
hw-monitor voltage-threshold
< slot > < index > < high > < low >
Sets the high and low voltage limits for raising an alarm on the
specified module and sensor.
slot
:
1-5
,
1
is the control card.
2-5
are the line cards.
index
: 1-3
high
: 0-25000 in mV
low
: 0-25000 in mV
C 13
Table 61
Hardware Monitor Commands Summary (continued)
COMMAND DESCRIPTION M P
Table 62
Running Configuration Commands Summary
COMMAND DESCRIPTION M P
copy running-config interface
dsl < slot >/< port > < slot/
portlist > [< attribute >
[<...>]]
Clones (copies) the attributes from the specified DSL port to other DSL
ports. Optionally, copies the specified attributes from one port to other
ports. E 13
copy running-config interface
ge-nni < port > < portlist >
[< attribute > [<...>]]
Clones (copies) the attributes from the specified GE NNI port to other
GE NNI ports. You can specify a single port <1>, all ports <*> or a list
of ports <1,2>. You can also include a range of ports <1-2>. E 13
copy running-config interface
voip < slot >/< port > < slot /
portlist > [< attribute >
[<...>]]
Clones (copies) the attributes from the specified VoIP port to other
VoIP ports. Optionally, copies the specified attributes from one port to
other ports. E 13
erase running-config
Resets the IES to the factory default settings. E 13
erase running-config
interface dsl < slot / portlist >
[< attribute > [<...>]]
Resets the specified DSL ports to the factory default settings on a per-
port basis and optionally on a per-feature configuration basis. E 13