ZyXEL Communications IES4005M, User Manual

Page: 148 / 236

Chapter 19 IPv6
IES4005M User’s Guide
148
19.1 IPv6 Commands Summary
This table describes the commands.
Table 101
IPv6 Commands Summary
COMMAND DESCRIPTION M P
ip inband address ipv6 < ipv6-
address >/< mask >
Manually configures a static in-band management IPv6 global address.
ipv6-address
: 2000:: ~ 3fff:ffff:ffff:ffff:ffff:ffff:ffff:ffff
mask
: 0 ~ 127
C 13
ip inband default-gateway
ipv6 < ipv6-address >
Manually configures a static in-band IPv6 global address for the default
outgoing gateway.
ipv6-address
: 2000:: ~ 3fff:ffff:ffff:ffff:ffff:ffff:ffff:ffff
C 13
no ipv6 inband
Removes the manually configured in-band management IPv6 address
and default gateway address. C 13
ip outband address ipv6
< ipv6-address >/< mask >
Manually configures a static out-of-band management IPv6 global
address.
ipv6-address
: 2000:: ~ 3fff:ffff:ffff:ffff:ffff:ffff:ffff:ffff
mask
: 0 ~ 128
C 13
no ipv6 outband
Removes the manually configured out-of-band management IPv6
address and default gateway address. C 13
ip ipv6 default-management
<inband|outband>
Sets whether the IES uses the in-band or out-of-band traffic flow to
send packets originating from itself (such as SNMP traps) or with an
unknown source. C 13
show ip ipv6
Displays the link-local addresses the IES generated automatically. This
also shows the manually configured inband/out-of-band management
IPv6 address and default gateway address. E 3
show ip ipv6 default-router
Displays IPv6 addresses of on-link routers that will help forward
packets. E 3
show ip ipv6 destination
Displays the mapping list of the next-hop address to an IPv6
destination address. E 3
show ip ipv6 neighbor
Displays the neighbor cache, which lists the MAC addresses of the IES's
interfaces and neighboring devices. E 3
show ip ipv6 prefix
Displays the list of on-link prefixes. The prefixes are used to determine
whether an IP address is on the same link as the IES or should be
reached through a router. A prefix is considered to be on-link when it is
assigned to an interface on a link. It's used to determine if an address
is on the IES's subnet and can be reached directly without passing
through a router. An on-link interface is directly connected to the IES or
connected through another switch. E 3
show ip ipv6 route
Displays the IPv6 routing table. E 3
show ip ipv6 default-
management
Displays packets’ default outgoing interface. E 3
ping ipv6 < ipv6-address >
[size < size >] [-t]
Sends Ping packets to the specified Ethernet device.
ipv6-address
: 2000:: ~ 3fff:ffff:ffff:ffff:ffff:ffff:ffff:ffff
size
: 0 ~ 1472
-t
: ping continuously until Ctrl-C is pressed
E 0