ZyXEL Communications IES4005M, User Manual

Page: 103 / 236

Chapter 11 Management
IES4005M User’s Guide
103
11.9 Performance Management
Use these commands for performance management.
11.9.1 Performance Management Commands Summary
The following table describes commonly used parameter notation for these commands.
This table describes the commands.
Table 70
performance management command parameters
Notation Description
alarm-profile
The name of an alarm profile. Use up to 31 printable characters.
portlist
The number of uplink port(s), 1-2. You can use 1,2, 1~2 or * to specify all the ports.
threshold
0 ~ 18446744073709551615. An alarm is triggered if this number is exceeded.
Table 71
performance management commands summary
Command Description M P
no ge-nni alarm-profile < alarm-
profile >
Deletes the specified Gigabit Ethernet (GE) port alarm profile. C 13
show ge-nni alarm-profile [ alarm-
profile ]
Displays all or the specified GE port alarm profile. E 13
ge-nni alarm-profile < alarm-
profile >
Enters the sub-command mode for configuring a GE port alarm profile. C 13
exit
Leaves the GE port alarm profile configuration sub-command mode. C 13
15min-txoctets-threshold
< threshold >
Configures the number of octets of Ethernet frames allowed to transmit
in any 15-minute period. C 13
15min-txpkts-threshold
< threshold >
Configures the number of packets allowed to transmit in any 15-minute
period. C 13
15min-txbcastpkts-threshold
< threshold >
Configures the number of broadcast packets allowed to transmit in any
15-minute period. C 13
15min-txmcastpkts-threshold
< threshold >
Configures the number of multicast packets allowed to transmit in any
15-minute period. C 13
15min-rxoctets-threshold
< threshold >
Configures the number of octets of Ethernet frames allowed to receive
in any 15-minute period. C 13
15min-rxpkts-threshold
< threshold >
Configures the number of packets allowed to receive in any 15-minute
period. C 13
15min-rxbcastpkts-threshold
< threshold >
Configures the number of broadcast packets allowed to receive in any
15-minute period. C 13
15min-rxmcastpkts-threshold
< threshold >
Configures the number of multicast packets allowed to receive in any
15-minute period. C 13
15min-rxcrc-threshold
< threshold >
Configures the number of CRC (Cyclical Redundancy Check) alignment
errors
allowed to occur in any 15-minute period.
C 13
15min-rxunder-threshold
< threshold >
Configures the number of packets that were too small allowed to
receive in any 15-minute period. C 13
15min-rxover-threshold
< threshold >
Configures the number of packets that were too big allowed to receive
in any 15-minute period. C 13
15min-rxfrag-threshold
< threshold >
Configures the number of fragmented frames allowed to receive in any
15-minute period. C 13