ZyXEL Communications IES4005M, User Manual

Page: 188 / 236

Chapter 25 VLAN
IES4005M User’s Guide
188
25.4.1 Command Examples
This example enables port 4 of the line card in slot 2 and also enables VLAN TLS with S tag VLAN
100 with S priority bit 0.
25.5 VLAN Translation and Aggregation Commands
VLAN translation changes the VLAN tag on traffic received from a subscriber port to another VLAN
ID for the service provider’s network. This makes it easier to deploy customer-specific VLANs
because all the CPE devices can use the same VLAN configuration. You only need to configure VLAN
translation on the IES to use unique VLAN IDs for each subscriber’s traffic. VLAN aggregation lets
the IES translate two or more different UNI VLAN IDs on a DSL port to a NNI VLAN ID.
See Section 25.1.4 on page 181 for more on VLAN translation and aggregation and command
examples.
The following table describes commonly used parameter notation for these commands.
This table describes the commands.
ras# config
ras(config)# interface dsl 2/4
ras(config-interface-dsl-2/4)# active
ras(config-interface-dsl-2/4)# vlan tls svlan 100 spbit 0
ras(config-interface-dsl-2/4)# exit
ras(config)# exit
ras# show vlan 100
S tag TPID: 8100 (hex)
single tag mode: ctag
VLAN ID 000 0 000001111111111222222222233333333334444444444555555555566666
100 123 4 567890123456789012345678901234567890123456789012345678901234
=========================================================================
slot 2:--- V ------------------------------------------------------------
slot 3:----------------------------------------------------------------
slot 4:----------------------------------------------------------------
slot 5:----------------------------------------------------------------
enet :--
ras#
Table 130
VLAN Translation and Aggregation Command Parameters
NOTATION DESCRIPTION
svid
The SVID (Service provider VLAN ID) 1-4093.
cvid
The CVID (Customer VLAN ID) 1-4093.
vpi
The VPI (Virtual Path Indicator) 0-255.
vci
The VCI (Virtual Channel Indicator) 32-65535.
Table 131
VLAN Translation and Aggregation Commands Summary
COMMAND DESCRIPTION M P
interface dsl < slot/portlist >
Enters the sub-command mode for configuring the specified DSL ports. C 13
exit
Leaves the DSL port configuration. C 13