ZyXEL Communications Dimension GS-3012, User Manual, Page: 232 / 259

GS-3012/GS-3012F User’s Guide
31-10 Command Examples
Remove the remote host with IP address 172.165.1.9 and with an SSH-RSA encryption key from the list of known
hosts.
Figure 31-19 no ssh Command Example
31.8 interface Commands
These are some commonly used commands that belong to the interface group of commands.
31.8.1 interface
Syntax:
interface
Each interface refers to an Ethernet port on the switch. Commands configured after the interface command
correspond to those ports. Type multiple ports or port ranges separated by a comma. Ranges of port numbers are
typed separated by a dash.
An example is shown next.
Enter the configuration command set.
Enable ports one, three, four and five for configuration.
Begin configuring for those ports.
Figure 31-20 interface Command Example
31.8.2 bpdu-control
Syntax:
bpdu-control <peer|tunnel|discard|network>
where
<peer|tunnel|d
iscard|network
>=
Type
peer
to process any BPDUs received on these ports.
Type
tunnel
to forward BPDUs received on these ports.
Type
discard
to drop any BPDUs received on these ports.
Type
network
to process a BPDU with no VLAN tag and forward a
tagged BPDU.
An example is shown next.
ras# config
ras(config)# interface port-channel 1,3-5
ras(config-interface)#
ras(config)# no ssh key rsa1
ras(config)# no ssh known-hosts 172.165.1.8
ras(config)# no ssh known-hosts 172.165.1.9 ssh-rsa