ZyXEL Communications Dimension GS-3012, User Manual, Page: 227 / 259

GS-3012/GS-3012F User’s Guide
Command Examples 31-5
31.4 traceroute
Syntax:
traceroute <ip> [in-band|out-of-band|vlan <vlan-id>][ttl <1-255>] [wait
<1-60>] [queries <1-10>]
where
<ip> = The IP address of an Ethernet device.
[in-band|out-of-
band|vlan <vlan-
id> ]
= Specifies the network interface or the VLAN ID to which the Ethernet
device belongs.
[ttl <1-255>]
= Specifies the Time To Live (TTL) period.
[wait <1-60>]
= Specifies the time period to wait.
[queries <1-10>]
= Specifies how many tries the switch performs the traceroute function.
This command displays information about the route to an Ethernet device. The following example displays route
information to an Ethernet device with an IP address of 192.168.1.100.
Figure 31-8 traceroute Command Example
31.5 Enabling RSTP
To enable RSTP on a port, enter
spanning-tree
followed by the port number. You also need to use
spanning-
tree
to enable RSTP on the switch. The following example enables RSTP on port 10.
Figure 31-9 Enable RSTP Command Example
31.6 Configuration File Maintenance
This section shows you how to backup or restore the configuration file on the switch using TFTP.
31.6.1 Backing up Configuration
Syntax:
copy running-config tftp <ip> <remote-file>
where
ras> traceroute 192.168.1.100
traceroute to 192.168.1.100, 30 hops max, 40 byte packet
1:192.168.1.100 (10 ms) (10 ms) (0 ms)
traceroute done:
ras(config)# spanning-tree 10
ras(config)# spanning-tree