
GS-3012/GS-3012F User’s Guide
Classifier
18-3
Table 18-1 Classifier
LABEL DESCRIPTION
Packet Format
Specify the format of the packet. Choices are
All
,
802.3 tagged
,
802.3 untagged
,
Ethernet
II tagged
and
Ethernet II untagged
.
A value of
802.3
indicates that the packets are formatted according to the IEEE 802.3
standards.
A
value of
Ethernet II
indicates that the packets are formatted according to RFC 894,
Ethernet II encapsulation.
VLAN Select
Any
to classify traffic from any VLAN or select the second option and specify the
source VLAN ID in the field provided.
Layer 2
Specify the fields below to configure a layer 2 classifier.
VLAN Select
Any
to classify traffic from any VLAN or select the second option and specify the
source VLAN ID in the field provided.
Priority Select
Any
to classify traffic from any priority level or select the second option and specify a
priority level in the field provided.
Ethernet Type
Select an Ethernet type or select
Other
and enter the Ethernet type number in hexadecimal
value. Refer to
Table 18-3
for information.
Source
MAC Address Select
Any
to apply the rule to all MAC addresses.
To specify a source, select the second choice and type a MAC address in valid MAC
address format (six hexadecimal character pairs).
Port Select the port to which the rule should be applied. You may choose one port only or all
ports (
All Ports
).
Destination
MAC Address Select
Any
to apply the rule to all MAC addresses.
To specify a destination, select the second choice and type a MAC address in valid MAC
address format (six hexadecimal character pairs).
Layer 3
Specify the fields below to configure a layer 3 classifier.
DSCP Select
Any
to classify traffic from any DSCP or select the second option and specify a DSCP
(DiffServ Code Point) number between 0 and 63 in the field provided.
IP Protocol
Select an IP protocol type or select
Other
and enter the protocol number in decimal value.
Refer to
Table 18-4
for more information.
You may select
Establish Only
for
TCP
protocol type. This means that the switch will pick
out the packets that are sent to establish TCP connections.
Source
IP Address/Address
Prefix
Enter a source IP address in dotted decimal notation.
Specify the address prefix by entering the number of ones in the subnet mask.
Summary of Contents for Dimension GS-3012
