Zontes ZT350T-D, Maintenance Manual

Page: 147 / 152

147 / 152
f. Use a Phillips screwdriver to remove two M4 × 16 bolts,
separate the rocker arm pressure block from the right lower
rocker arm. Remove 2 pieces of rocker arm buffer rubber
from the rocker arm pressure block. Remove the left lower
rocker arm in the same way.
g. Remove M8× 16 Bolts with 6 # hexagonal socket,
remove the gasket, bearing and upper rocker arm.
Disassembly the middle cover of the fuel
tank
a.Connect the positive and negative terminals of the main
wiring harness of the battery to open the tank lock or open
the tank lock before removing the battery; Remove the
M6x12 bolt
⑴
fixing the oil tank cover with the 4# inner
hexagon, and unscrew the threaded oil tank
b. Grasp the mark (green rectangle) on the middle cover of
the fuel tank and pull it out in the direction of the arrow until
the mushroom button (red circle) on the middle cover of the
fuel tank is pulled out.
c. Find and unplug the fuel tank lock connector from the
left side of the fuel tank, and sort out the harness of the fuel
tank lock.
d. Remove the oil tank cover; Press the cushion bracket
with one hand and take out the middle of the tank cover
plate with the other hand.
Caution: When taking out the middle part of the tank
cover plate, it is necessary to pay attention to the wiring
harness of the tank lock, so as not to get stuck and avoid
pulling the wiring harness of the tank lock; to prevent dirt
matters from entering the tank, immediately screw the tank
cover back to the tank after removing the middle cover.
e. Press the big arrow to break the clip fixing the fuel tank
lock to both sides and then remove the fuel tank lock; Press
the small arrow to press the buckle of the fuel tank cover and
fuel tank bracket towards the middle, and then remove the
fuel tank cover and fuel tank lock. Pay attention to the
strength when breaking the buckle to avoid breaking.
f. Take down the circlip with pointed nose pliers and pull
out the rotary shaft. Remove the torsion spring and damping.
Pay attention to the position of the torsion spring during
installation.