Zontes ZT350T-D, Maintenance Manual, Page: 134 / 152

134 / 152
b. Put the bearing (9), shaft ring (8) and dust cover (7)
smeared with grease on the lower yoke plate in turn, screw
in one adjusting nut (5) of the steering column, and tighten
the adjusting nut (5) of the steering column with a four jaw
socket with a torque of 50N. m (5.1 kgf. m, 37 lbf. ft). After
ensuring that the upper yoke plate does not move up and
down in tandem, loosen the adjusting nut (5) of the steering
column by 1/4 turn counterclockwise, and finally tighten it
with a torque wrench. Torque: 15N. m (1.2 kgf. m, 11 lbf. ft).
Put rubber gasket (6) on the adjusting nut of steering column;
Then screw in the second steering column adjusting nut (5),
screw the second steering column adjusting nut (5) to align
with the gap of the first steering column adjusting nut (5),
and finally put in the snap washer (4).
c. Install the steering handle seat block and lower yoke
plate, put in the gasket (3), and finally screw in the cap nut
(2) with a torque of 100N. m (10.2 kgf. m, 74 bf. ft)
6. Install other disassembly components
a. Refer to "Replace the front shock absorber" to replace
the front shock absorber.
b. Refer to "Replace the front wheel" to reinstall the front
wheel assembly.
c. Refer to "Replace the direction handle" to install the
assembly back in the direction.
d. Install the head cover back according to Disassembly of
Covers
●The vehicle must be parked on a level and stable ground or
on a lifting platform.